Easter Egg Stencils
ID: 2611
$1.00
3D Model Details
-
Texture: No
-
Multipart model: Yes
-
File format: stl
-
File size: 3.69 MB
-
Upload date: 03/19/2015
-
Last update: 03/19/2015
Description
Decorate your eggs with these stencils.
Stencils were inspired by discussions of an upcoming Easter egg dying session. The original thought was that you could pour hot candle wax through the stencil then take the egg out and dye it normally. The wax would seal the shell from the dye and you could scrape it off after drying. It may also be possible to use small paint brushes to decorate through the stencil. These stencils are designed to fit large grade AA eggs. I would print these at .2 mm layer height, 20% infill, facing with the flat part down with supports. (I found that the orientation was important to get the cross and chick one to successfully print.)
Stencils were inspired by discussions of an upcoming Easter egg dying session. The original thought was that you could pour hot candle wax through the stencil then take the egg out and dye it normally. The wax would seal the shell from the dye and you could scrape it off after drying. It may also be possible to use small paint brushes to decorate through the stencil. These stencils are designed to fit large grade AA eggs. I would print these at .2 mm layer height, 20% infill, facing with the flat part down with supports. (I found that the orientation was important to get the cross and chick one to successfully print.)
Report this design
